Try For Free

Disable users not found in the Connector

If you want to disable a user that cannot be found during a single-user sync on the identity provider site, you can enable the corresponding setting in the connector settings in the Sync Settings tab.

Default Configuration

Whenever the username in your Atlassian application matches the username in your identity provider, the below configuration will do.


image2023-2-22_15-57-53.png

Advanced Configuration

If your connector has a mapping for the username (Provisioning Settings/ Attribute Mapping/ Username) that is using a different value than the username on the identity provider side, you need to change a few things before.

Example

You've mapped Okta's profile.sAMAccountName attribute to the Username

image2023-2-22_16-8-51.png

Add a new attribute mapping of type Crowd Attribute ...

image2023-2-22_16-10-20.png

... give it a name and press Next

image2023-2-22_16-11-37.png

Then select the attribute from the identity provider for the default username and click apply.

image2023-2-22_16-12-49.png

You'll now see a new attribute in the list.

image2023-2-22_16-14-27.png

This will only become available after running a full sync for all your users. But you can already complete the configuration and select the new attribute in the Sync Settings tab:

image2023-2-22_16-16-59.png

The Attribute (as sent by Connector) needs to be called identifier for that to work. If it's set to something else, click on the edit button, write it into the Source Attribute Name field and click on Create "identifier"

image2023-2-22_16-23-24.png

Don't forget to save your connector configuration and run the full sync mentioned earlier.